Savin G1619 - Manual (Page 155)

Using Key Operator Settings
67
6
JJJJ
Enter the Memory Lock ID (4-dig-
its) with the number keys.
If you make a mistake, press the
{{{{Clear/Stop}}}} key and try again.
KKKK
Press the
{{{{OK}}}} key.
If you want to enter another item,
repeat the above steps from step
I.
LLLL
Press the
{{{{User Tools}}}} key to re-
turn to the standby display.
Line Type
You must register the Line Type be-
fore you connect the machine to the
line.
Note
❒ This function is not available in
some areas.
❒ If you do not know the type of line
you are connected to, select "Tone"
and dial a trial number. If the con-
nection was successful, your Line
Type is "Tone", if it was not, set the
Line Type to "Pulse" and dial a trial
number. If the connection was suc-
cessful, your Line Type is "Pulse".
Limitation
❒ If you do not correctly set the Line
Type, you will be able to receive
messages, but you may not be able
to send them.
To register the Line Type, perform the
following procedure.
AAAA
Press the
{{{{User Tools}}}} key.
BBBB
Press
0 0 0 0 or 1 1 1 1 until "4. Fax Fea-
tures" is displayed.
CCCC
Press the
{{{{OK}}}} key.
DDDD
Press
0 0 0 0 or 1 1 1 1 until "4. Key Op.
Tools" is displayed.
EEEE
Press the
{{{{OK}}}} key.
FFFF
Press
0 0 0 0 or 1 1 1 1 until "6. Line Type"
is displayed.
GGGG
Press the
{{{{OK}}}} key.
HHHH
Press
0 0 0 0 or 1 1 1 1 and select "Tone" or
"Pulse".
IIII
Press the
{{{{OK}}}} key.
JJJJ
Press the
{{{{User Tools}}}} key to re-
turn to the standby display.