Savin G1619 - Manual (Page 36)

Faxing
26
2
Dialing
There are four main ways to dial a
number:
❖ ❖ ❖ ❖ Entering Numbers Directly
See p.26 “Entering Numbers Di-
rectly”
❖ ❖ ❖ ❖ Using Quick Dials:
See p.27 “Using Quick Dials”
❖ ❖ ❖ ❖ Using Speed Dials:
See p.28 “Using Speed Dials”
❖ ❖ ❖ ❖ Using Groups
See p.29 “Using Groups”
Entering Numbers Directly
Enter numbers directly using the
number keys on the right side of the
operation panel.
Note
❒ Maximum length of a fax number:
254 digits.
❒ You can insert pauses and tones in
a fax number. See p.27 “Pause”,
p.27 “Tone”
AAAA
Make sure that the machine is in
standby mode.
BBBB
Set your original and select any
scan settings you require.
CCCC
Enter the fax number with the
number keys.
The digits appear on the display as
you enter them.
Note
❒ If you make a mistake, press the
{{{{Clear/Stop}}}} key and enter
again.
❒ If you wish to send this message
to more than one destination,
press the
{{{{OK}}}} key, and then en-
ter the next destination.
DDDD
Press the
{{{{Start}}}} key.
- - - -Limitations when dialing with
the number keys
Fax numbers entered with the num-
ber keys are stored in internal memo-
ry (separate from memory for storing
original data). Therefore, using the
number keys, you cannot program
more than 67 numbers for the follow-
ing:
• Destinations specified in a Memo-
ry Transmission (including Polling
Reception)
• Destinations specified in a Group
For example, when 60 destinations
are registered in a Group with the
number keys, only 7 destinations can
be dialed for Memory Transmission
from the number keys.