Savin G1619 User Manual
Page 150
Key Operator Settings
62
6
HHHH
Press the
{{{{OK}}}} key.
For a list of the switches and set-
tings, see p.58 “User Parameters”.
Use the User Parameters table to
look up the number of the switch
that you want to change, and then
press the
0 or 1 key to display
the number of the switch.
The bits are numbered 7~0. To
change a setting, press the corre-
sponding number key to toggle the
setting between "0" and "1"
For example, if you want to change
the setting at bit 7, press the 7 num-
ber key to toggle the setting be-
tween "1" and "0".
IIII
When you are finished making
adjustments, press the
{{{{OK}}}} key.
JJJJ
Press the
{{{{User Tools}}}} key to re-
turn to the standby display.
Printing the User Parameter List
Print this list to see the current User
Parameter settings.
AAAA
Press the
{{{{User Tools}}}} key.
BBBB
Press
0
0
0
0 or 1
1
1
1 until " 4. Fax Fea-
tures " is displayed.
CCCC
Press the
{{{{OK}}}} key.
DDDD
Press
0
0
0
0 or 1
1
1
1 until " 4. Key Op.
Tools " is displayed.
EEEE
Press the
{{{{OK}}}} key.
FFFF
Press
0
0
0
0 or 1
1
1
1 until " 3. User Pa-
rameters " is displayed.
GGGG
Press the
{{{{OK}}}} key.
HHHH
Press the
0
0
0
0 or 1
1
1
1 key until " 2.
Print List " is displayed.
IIII
Press the
{{{{OK}}}} key.
JJJJ
Press the
{{{{Start}}}} key to print the
list.
Note
❒ If you press the {{{{Cancel}}}} key be-
fore printing starts, the list will
not be printed and the display
shown in step
H appears again.
Key to
Press
7
6
5
4
3
2
1
0
SW 00: 1
0
0
0
0
1
1
0