D 145), Ble 145, E 145). t – Seagate Fibre Channel Interface User Manual

Page 229

Advertising

Fibre Channel Interface Manual, Rev. D

215

Page Length
The length of the mode parameters that follow (in bytes). If the initiator does not set this value to the value that is returned
for the page by the Mode Sense command, the drive terminates the command with Check Condition status. The sense key
is set to Illegal Request with the additional sense code set to Invalid Field in Parameter List. The drive is permitted to imple-
ment a mode page that is less than the full page length defined by this specification, provided no field is truncated and the
page length field correctly specifies the actual length implemented. If the Strict bit equals zero and if the page length speci-
fied by the initiator is shorter than the actual page length, then the parameters are transferred and the command ends with
Good status if no other items cause the command to be rejected.

Caution:

Data integrity may be adversely affected if an initiator uses this forgiving option without analyzing the impact of
the truncation.

See the individual page code descriptions for specific page lengths.

PS (Parameter Savable)
1

Page contains savable parameters.

None of the parameters within the page are savable.

Since the parameters within pages 3 and 4 are always saved during Format commands (but not by a Mode Select com-
mand with the SMP bit set to 1), these pages return a 1 for the PS bit.

Table 145: Mode sense page code section reference

Page code

Page description

Reference table

00h

Unit Attention page

146 (page 216)

01h

Error Recovery

147 (page 218)

02h

Disconnect/Reconnect Control