Seagate Fibre Channel Interface User Manual
Page 283
Fibre Channel Interface Manual, Rev. D
269
0
The target satisfies the command by accessing the cache memory. For read operations, any logical blocks that are
contained in the cache memory are transferred to the initiator directly from the cache memory.
Logical Block Address
The logical block at which the read operation begins, if RelAdr bit is zero (see RelAdr bit description).
RelAdr (Relative Address)
This function is not supported by drives described in this manual.
Transfer Length
The number of contiguous logical blocks of data transferred. A Transfer Length of zero (0) indicates that no logical blocks
are transferred. This condition is not considered an error. Any other value indicates the number of logical blocks that are
transferred.
If any of the following conditions occur, this command returns a Check Condition status and the sense key is
set as indicated. This list does not provide an exhaustive enumeration of all conditions that cause the Check
Condition status.
Condition
Sense Key
Invalid logical block address
Illegal Request. Set the extended sense information bytes to the
logical block address of the first invalid address.
Target reset since last command from this initiator
Unit Attention
Unrecovered read error
Medium Error
Recoverable read error
Recovered Error