Seagate Fibre Channel Interface - Manual (Page 341)

Fibre Channel Interface Manual, Rev. D 327
This command operates the same as the Write (6) command (Section 12.57) except that in the CDB for this
command a four-byte logical block address and a four-byte transfer length may be specified.
This command terminates with a Reservation Conflict status if any reservation access conflict (see Section
12.39) exists, and no data is written.
If any of the following conditions occur, this command terminates with a Check Condition status and the sense
key is set as indicated in the following table. This table does not provide an exhaustive enumeration of all con-
ditions that cause the Check Condition status.
Condition Sense Key
Invalid logical block address Volume Overflow. Set the extended sense information bytes to
the logical block address of the first invalid address.
Target reset since last command from this initiator Unit Attention