SmartBridges sB3010 - Manual (Page 14)

Page 14 of 82
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul™ Nexus User Guide
The page information descriptions are provided in the table below:
Table 2-1 Page Information Descriptions
2.2. Web GUI Administrator Password Change
By default the Administrator password is smartBridges (case sensitive).
Follow the steps below to change the Administrator password.
1. Click on the ‘ Tools | User Manager ’ drop down menu in the navigation menu bar. An
‘ Administrator Password change ’ GUI will appear.
2. Enter the fields
‘ Old Password ’ , ‘ new Authentication Password ’ and ‘ Confirm new
Authentication Password ’ as shown in Figure 2-4.
3. Click on the
‘ Apply Changes ’ button to effect the password change.
Page Item Descriptions
IP Address Editable Ethernet IP Address.
IP Mask Editable Ethernet IP subnet Mask
Gateway Editable Gateway IP address. Ethernet
Configuration DHCP Editable DHCP status Disabled/Enabled
User can enable DHCP by ticking the check box to obtain
an IP address from the network DHCP server
SSID Device SSID.
Channel
Device operation channel.
RSSI RSSI value when associated
Wireless
Configuration
Maximum Wireless
Throughput
Maximum Wireless Throughput in kbps
ETH A MAC Address Ethernet A (wired side) MAC address.
Display only
ETH B MAC Address Ethernet B (wired side) MAC address.
Display only
Port
Information
Radio MAC Address Radio MAC address.
Display only
Operational
Mode
Device operational
mode
Current device operational mode, either as Root Bridge,
Remote Bridge or Remote Router