SmartBridges sB3010 - Manual (Page 67)

Page 67 of 82
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul™ Nexus User Guide
The following page shows the Link Test for the Remote Devices:
Figure 7-8 Link Test Result
7.3.1 Throughput Test
Follow the steps below to do a Throughput Test:
1. Set up a link between two airHaul units (one in Root Bridge mode and another in Remote
Bridge or Router mode).
2. Enter a valid IP address of the far-end Radio.
3. Click on the ‘Radio Receive’ or ‘Radio Transmit’ button.
4. The Throughput test will start and the result will be displayed.
5. Click the ‘Stop’ button to stop the test.