SmartBridges sB3010 - Manual (Page 20)

Page 20 of 82
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul™ Nexus User Guide
2.5. Device Mode Configuration
The current device operational mode is displayed at the top right hand corner of each page. The
Device Mode Configuration allows the user to configure the airHaul Operational mode to Root Bridge,
Remote Bridge or Remote Router mode.
By default, airHaul unit is set to Root Bridge Mode.
Follow the steps below to configure the airHaul unit in Root Bridge Mode:
1. Go to the System Configuration page and choose the Operational Modes available for
airHaul: Root or Remote.
Note: The Root device can only be configured as a Bridge and the Remote device can be
configured either as a Bridge or Router.
2. Click on the Apply Changes button to change the settings. The device will be rebooted and
set to the chosen operational mode.
Figure 2-7 Radio Operational Mode Settings