SmartBridges sB3010 - Manual (Page 36)

Page 36 of 82
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul™ Nexus User Guide
2.7.2 Wireless Configuration
The wireless parameters need to be configured to allow the Remote Bridge airHaul unit to associate
with a Root Bridge airHaul unit.
Follow these steps below to configure the Remote Bridge Mode wireless association parameters:
1. Go the menu bar and select Main – Remote Bridge Mode from the Radio drop-down menu.
2. Enter the SSID of the Root Bridge airHaul unit.
3. Enter the radio MAC address of the Root Bridge airHaul unit.
4. Choose a radio domain from the drop down list.
5. Choose a radio channel to associate the client with the root device.
6. Select the Transmit power of the radio from Dial in Power drop down menu
7. Select the gain of the antenna from the drop down menu as per the gain of the antenna being
used with the equipment.
8. Enter the RF cable loss based on the cable specifications
9. Click the Apply Changes. The units will attempt to associate.
Note: Clicking on ‘Status’ will display further details on the association
Figure 2-21 Remote Bridge Wireless Settings