SmartBridges sB3010 - Manual (Page 38)

Page 38 of 82
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul™ Nexus User Guide
2.8. Remote Router Configuration
The airHaul units can also be configured to operate as a Remote device to associate to Root Bridge.
In Remote mode, the unit can operate as a bridge or a router.
Follow the steps in section 2.7.2 to 2.7.6 to configure the device in Remote Router mode
.
2.8.1 Ethernet Configuration
The Ethernet IP is configured during the operational mode change to the Remote Router mode.
Follow these steps below if you need to re-configure the Remote Router Ethernet parameters:
1. From the ’Summary Information’ page, click on the ‘Ethernet Configuration’ link to change
Ethernet parameters.
2. Enter the ‘IP address’ and ‘IP mask’.
3. Click on the ‘Apply Changes’ button to change the settings.
Figure 2-23 Remote Router Ethernet Configurations