SmartBridges sB3010 - Manual (Page 43)

Page 43 of 82
i n t e l l i g e n t w i r e l e s s p l a t f o r m
airHaul™ Nexus User Guide
2.8.4 DHCP Relay Configurations
If the user has a DHCP Server, the Remote Router airHaul device can be configured as a DHCP
Relay agent of the DHCP Server for IP address assignment.
Follow the steps below to configure the Remote Router unit as a DHCP Relay Agent:
1. Click on ‘Networking’ | ‘DHCP Server’ from the drop down menu to access the DHCP
Configuration page.
2. Click on ‘Enable DHCP Relay’ to choose DHCP Relay mode.
3. Enter a valid DHCP Server IP.
4. Click on the ‘Apply Changes’ to start the DHCP relay agent.
Note: The system will validate the input parameters and notify users of invalid entries.
The DHCP Server IP will be in the same network segment as the device wireless Radio IP
address.
The DHCP Server needs to be configured to serve IP range of the wired side Ethernet IP.
The DHCP Relay Agent is only available to hosts connected to the same LAN segment as the
device wired-side Ethernet port.
Figure 2-29 DHCP Relay Agent Configurations
Follow the steps below to disable the Remote Router DHCP Relay Agent:
1. Click on ‘Networking’ | ‘DHCP Server’ from the menu bar to access the DHCP configuration
page.
2. Click on ‘Disable DHCP and DHCP Relay’ to disable the DHCP server configuration.
3. Click on the ‘Apply Changes’ to change the settings