Samsung Digimax 250 - Manual (Page 67)

67
Selecting Video out type
The Movie output signal from the camera can be NTSC or PAL. Your choice of output will be
governed by the type of device (monitor or TV, etc.) to which the camera is connected. PAL
mode can support only BDGHI.
Setting the Video Out Type
1. In any mode other than Voice Recording mode, press the
MENU button.
2. Press the LEFT/ RIGHT button and select the [SETUP]
menu tab.
3. Select the [VIDEO] menu by pressing the UP/ DOWN
button and press the RIGHT button.
4. Select a desired sub menu by pressing the UP/ DOWN
button and press the OK button.
- [VIDEO] sub menu : NTSC, PAL
5. Press the menu button twice and the menu will disappear.
NTSC : U.S.A, Canada, Japan, South Korea, Taiwan, Mexico.
PAL : Australia, Austria, Belgium, China, Denmark, Finland, Germany, U.K., Holland,
Italy, Kuwait, Malaysia, New Zealand, Singapore, Spain, Sweden, Switzerland,
Thailand, Norway.
When using a TV as an external monitor, you will need to select the external or AV
channel of the TV.
There will be a digital noise on the external monitor, but it is not a malfunction.
If the image is not in the centre of the screen, use the TV controls to centre it.
When the camera is connected to an external monitor, the menu will be visible on the
external monitor and the menu functions are the same as those indicated on the LCD
monitor.
INFORMATION
Connecting to an external monitor
In RECORDING/ PLAY mode, you
can view the stored still images or
movie clips by connecting the
camera to an external monitor via the
VIDEO cable. When the camera is
connected to an external monitor, the
LCD monitor will be turned off
automatically.
Yellow - Video
SETUP
BEEP
LCD
VIDEO
BACK: SET:OK
NTSC
PAL