Silex technology WLAN MODULE SX-550 - Manual (Page 33)

Accessing Configuration Parameters silex Page 27
Part Number 40183-101
7. Select Configuration. The Server Configuration window displays as shown in Figure 14.
Figure 14 ExtendView Configuration Window
8. If no DHCP server exists, Extendview will prompt for a password before the configuration page
displays. If you are unsure of the IP address, check with your network administrator.
9. If using a wireless SX-550 module, configure the wireless settings by selecting country or region for
the region of operation.
N OTE : It may not be legal to operate the SX-550 module in a country or region other than the country
or region shown in the drop-down list. If your country or region is not listed, please check with your
local government agency.
Set the wireless mode as ad-hoc or infrastructure, SSID channel, and WEP encryption of the wireless
SX-550 module to the same configuration as the wireless network where you are communication. All
nodes must have the identical same settings to communicate with each other.
10. Continue to Chapter 6:
Setting Configuration Parameters.
Access HTTP Pages
You can manage and configure the SX-550 module using a standard web browser, such as Internet
Explorer or Mozilla Firefox.
N
OTE : Prior to accessing the SX-550 module, you must configure the IP on both the computer and SX-
550 module.
To access the HTTP Pages:
1. Connect an Ethernet cable from your network hub to the SX-550 module.
2. Power on the computer and SX-550 module.
If the SX-550 module is connected to a serial device that cannot display or print ASCII characters,
then it is recommended that another serial device capable of displaying or printing ASCII characters
be temporarily connected to the SX-550 module. This ensures you can view the IP address assigned
by the DHCP server to the SX-550 module. The IP address must be different than the IP address
used by the computer.