Silex technology WLAN MODULE SX-550 - Manual (Page 68)

Page 62 silex Console Commands
Part Number 40183-101
Command Description
SET NW
WPATRACE Sets WPA trace level.
This command is for diagnostic purposes only.
The default value is 0 or disabled.
Sample output:
SET NW WPATRACE nn
Port Commands
Table 40 Port Commands
Command Description
SH PORT Shows port parameters
Sample output:
Port Q-Size Type Attributes
*S1 0 serial 115200 N 8 1
XON/XOFF RS232
SET PORT Sets port parameters.
The commands are dependent on the port type.
CLEAR PORT S1
JOB Aborts the active job on the port.
If the remote host is connected, additional data received will be discarded.
Sample output:
CL PORT S1 JOB
SET PORT S1
FLOW Sets serial port flow control to NONE, XON/XOFF, CTS, or DSR
The default value is none.
Sample output:
SET PORT S1 FLOW <flow>
SET PORT S1
PARITY Sets serial port parity to NONE, EVEN, ODD, MARK, or SPACE
The default value is none.
Sample output:
SET PORT S1 Parity <parity>
SET PORT S1
SIZE Sets data bits on the serial port
The default value is 8.
Sample output:
SET PORT S1 Signal [7 | 8]
SET PORT S1
SPeed Sets serial port baud rate. Options for BAUD are 300, 600, 1200, 2400, 7200, 9600,
19200, 38400, 57600, 115200, 230400, and 460800
The default value is 115200.