Silex technology WLAN MODULE SX-550 - Manual (Page 34)

Page 28 silex Accessing Configuration Parameters
Part Number 40183-101
To send configuration data to the serial device, press the Test button on the SX-550 module. The
serial device should display or print the IP address assigned to the SX-550 module by your network
DHCP service.
If your network does not use DHCP, then the SX-550 module will have the default IP address of
192.0.0.192.
Note: When using the SX-550 module wirelessly, verify you are communicating using AdHoc mode
with the SSID configured as ‘serserv.’
3. Enter the password. The default password is ACCESS. The SX-550 configuration home page
displays.
Figure 15 SX-550 Home Page
4. Continue to Chapter 6:
Setting Configuration Parameters.
Access Internal Command Console
You can access the Command Console by using the following methods:
• SX-550 Evaluation Daughtercard’s Ethernet port using a Telnet session
• SX-550 Evaluation Daughtercard’s serial port or console port using a terminal emulator