Silex technology WLAN MODULE SX-550 - Manual (Page 46)

Page 40 silex Setting Configuration Parameters
Part Number 40183-101
Figure 21 SNMP Traps
2. Configure the settings as defined in Table 24.
Table 24 SNMP Trap Settings
Parameter Setting
Protocol Sets the protocol
Trap Destination – TCP/IP Address Sets the IP address for the trap destination
Port Sets the port location
Port Traps Sets the port traps
GPIO Traps Sets the GPIO traps
3. To accept changes, click OK.
To cancel, click Cancel.
For additional help, click Help.
Configuring GPIO Alerts and Traps
The SX-550 module has eight General Purpose I/O (GPIO) lines available for use on connector J7.
These GPIO lines are individually programmable for either input, output, or special purpose. By default,
all the GPIO lines are configured for special purpose use.
Lines configured for input can be used as a source for SNMP traps and/or email alerts. The GPIO
direction, trigger settings, and email/web page message strings are configured from the Internal
Configuration Console interface.
Table 25, Table 26 and Table 27 describe the GPIO Commands.