Silex technology WLAN MODULE SX-550 - Manual (Page 78)

Page 72 silex Console Commands
Part Number 40183-101
Command Description
This command is used for diagnostic purposes only.
The default value is Disable.
Sample output:
SET LOAd (ENable | DIsable ]
SET LOAd HOst Sets the node name of the Netware boot host.
This command is used for diagnostic purposes only.
The default value is null>\
Sample output:
SET LOAd HOst <name>
SET LOAd IP Sets source computer IP address for TFTP get operation.
The default value is 0.0.0.0.
Sample output:
SET LOAd IP aa.bb.cc.dd
SET LOAd
SOftware Sets filename on host for TFTP get update
Sample output:
SET LOAd SOftware <filename>
SET LOAd TFTP Initiates firmware update using TFTP get operation.
The TFTP server address must be set using SET LOAd IP and the filename using
SET LOAd SOftware. The server will reset after the firmware update is completed.
Sample output:
SET LOAd TFTP
SET LOAd
XModem Initiates firmware update using the XModem protocol on the serial console
The server will reset after the firmware update is completed.
Sample output:
SET LOAd XModem
SH LOAd Shows the firmware update parameters
Sample output:
Firmware load is disabled
Load Host IP = 0.0.0.0
Software file = xxxx.bin
Load Host Name =