Silex technology WLAN MODULE SX-550 - Manual (Page 35)

Accessing Configuration Parameters silex Page 29
Part Number 40183-101
• SX-550 Web Page Configuration
Using Telnet Session
To access using telnet:
1. Connect the SX-550 module’s Ethernet cable to the host computer.
2. On the Windows main page, select Start>Run. The Run window displays.
3. Type the following command, then click OK.
telnet x.x.x.x
where x.x.x.x is the IP address of the SX-550 module
The default port is 23.
4. When the connection is established, press Enter. The # prompt displays.
5. Type the password (default is ACCESS), then press Enter. The password will not echo on your
screen.
6. Press Enter until the Local> prompt displays. No user name is necessary. You can begin configuring
the SX-550 module.
Continue to Chapter 6:
Setting Configuration Parameters.
N
OTE : For the list of console commands, refer to Appendix A:
Console Commands.
Using Terminal Emulator through the Serial Port
To access using the serial port:
1. Attach the null modem serial cable from the DB9 serial port on the SX-550 module to the COM port
on the computer.
2. If you do not wish to cycle the SX-550 module’s power to enter the console mode, continue to
step 3.
To enter the console mode by cycling the SX-550 module’s power, press and hold the SX-550
module’s test button for at least three seconds while powering the device.
The SX-550 module will begin initializing.
3. Start a terminal emulation program, such as Windows HyperTerminal, by selecting
Start/Programs/Communications/HyperTerminal. The Connection Description window displays.
4. Type a name for the connection, then click OK. The Connect To window displays.
5. In the Connect Using list box, select a connection, then click OK. The default is COM1.
The COM Properties window displays.
6. On the Port Settings tab, select the settings shown in Table 15, then click OK.