Sanyo TLS-9024P - Manual (Page 12)

CHANGING THE ON-SCREEN DISPLAY
Selecting the On-screen Display
You can select to display or not the date, time, the
number of alarm recordings and tape speed.
1
Turn the power on to all devices used.
2
Press the MENU button until the (SET UP 2) menu
is displayed.
@@@@@@@<SET@UP@2>
öDISPLAY
@@@DATE@@@@@@@@@@@Y
@@@TIME@@@@@@@@@@@Y
@@@ALARM@COUNT@@@@Y
@@@SPEED@@@@@@@@@@Y
öBUZZER
@@@ALARM@IN@@@@@@@Y
@@@TAPE@END@@@@@@@Y
@@@KEY@IN@@@@@@@@@N
@@@WARNING@@@@@@@@Y
3
Turn the JOG dial clockwise, until the desired item
for which the display function will be set is flashing.
4
Turn the SHUTTLE ring to set “Y” for the functions
described below.
DATE . . . . . . . . . . . The date is displayed
TIME . . . . . . . . . . . . The time is displayed
ALARM COUNT . . . The number of alarm
recordings is displayed
SPEED . . . . . . . . . . The recording/playback
speed mode is displayed
5
Press the SEARCH/AUDIO ON button to save the
settings.
NOTE:
œ If the ON SCREEN switch is set to the “ON” position,
the items for which “Y” is set are recorded. The items
for which “N” was set at step
4 above are not
recorded.
Changing the Date/Time Display
Position
1
Turn the power on to all input devices to the VCR.
2
Set the ON SCREEN switch to the “ON” position.
ø The date and time are displayed.
15-10-99@FRI@000
15:20:00@@@3
3
Press the SHIFT « (or ] ) button.
ø The display will move towards the right (or the
bottom).
NOTES:
œ If the SHIFT « (or ] ) button is kept pressed for 1
second or more the display will move at a faster
speed.
œ The display position cannot be changed while
recording.
RR4Q/EX2 (TLS-9024P GB) Fri. Sept., 29/2000
English
11