Sanyo TLS-9024P - Manual (Page 15)

NORMAL RECORDING
Normal Recording
œ Turn the power on to all devices used.
œ Load a cassette tape with erasure-prevention tab.
œ Set the ON SCREEN switch to the “ON” position.
1
Press the REC/PLAY SPEED l (or j ) button to set
the recording speed mode.
ø The recording speed mode is displayed
on-screen and on the digital display.
2
Press the REC button.
ø The record indicator “ m ” light.
ø Recording starts.
ø When the end of the tape is reached, “OFF”
will be displayed.
NOTES:
œ If in the (SET UP 2) menu, in the BUZZER
section TAPE END is set to “Y”, the buzzer will
be heard as long as “OFF” is displayed on the
digital display.
œ To cancel the “OFF” display, press the STOP,
EJECT or PLAY button or turn the SHUTTLE
ring.
œ If recording stops due to a problem with the tape
or other reason, the unit will try once to resume
recording. If the tape still does not advance, the
VCR will go into stop mode.
3
To stop recording, press the STOP button.
NOTES:
œ A tape recording made on this VCR may not play
back with the same degree of clarity on a time lapse
from another manufacturer.
œ If you press on the REC button and the loaded
cassette has no erasure-prevention tab, the VCR will
eject the cassette.
[Recording Speed Mode]
Recording
speed mode
(hour mode)
Maximum
recording
duration
(hours)
Recording
interval
(second)
Audio
recording
Tape motion
3 3 1/50
Possible Continuous 12 15 5/50
24 27 9/50
Record Pause
Recording can be interrupted temporarily.
1
Press the STILL/PAUSE button during recording.
ø The Pause/Still indicator “ N ” blinks.
NOTES:
œ The image appears on-screen but it is not
recorded.
œ If a recording pause continues for 5 minutes or
more, the VCR will go into stop mode to avoid
damaging the tape.
2
To resume recording, press the REC button, or
press the STILL/PAUSE button again.
Before starting
RR4Q/EX2 (TLS-9024P GB) Fri. Sept., 29/2000
14
English