Sanyo TLS-9024P - Manual (Page 19)

ALARM RECORDING
By connecting the ALARM IN terminal to a door switch,
an interphone, etc., a recording can be done only when
necessary.
Alarm Recording Setting
Alarm recording is performed when there is an input
(trigger) at the ALARM IN terminal, “AL” is displayed on
the digital display.
œ Make all necessary connections.
œ Follow the Before starting steps, under “NORMAL
RECORDING”.
1
Press the MENU button until the (SET UP 3) menu
is displayed.
@@@@@@@<SET@UP@3>
öALARM@MODE@@@@@@@Y1
öALARM@SPEED@@@@@@3H
öALARM@DURATION@@@20S
öTAPE@END@MODE@@@@REW
öTAPE@END@OUT@@@@@-3M
öCLOG@DETECT.@@@@@Y
öRS-232C@@@@@@@@@@19200
2
Turn the SHUTTLE ring to set the desired alarm
mode.
Y1 . . . . . . . . Alarm recording is done when there
is an alarm trigger.
Y2 . . . . . . . . Alarm recording is done only when
there is an alarm trigger during
programmed timer recording.
Y3 . . . . . . . . Alarm recording is done only if there
is an alarm trigger and the VCR is
not in programmed timer recording
mode.
Y4 . . . . . . . . Alarm recording is done only when
there is an alarm trigger during
programmed timer recording
duration. Timer recording is not
possible.
N . . . . . . . . . Alarm recording is not performed
even if there is an alarm trigger.
3
Turn the JOG dial, until the “ALARM SPEED”
setting is flashing.
4
Turn the SHUTTLE ring, to select the desired
recording speed.
3H . . . . . . . . 3-hour mode recording
12H . . . . . . . 12-hour mode recording
24H . . . . . . . 24-hour mode recording
NC . . . . . . . . Recording at the speed already set
5
Turn the JOG dial, until the “ALARM DURATION”
setting is flashing.
6
Turn the SHUTTLE ring, to select the desired alarm
recording duration (20S, 40S, 1M, 2M, 3M, 4M, 5M,
or CC).
20S-5M. . . . Recording only for the displayed
duration
CC . . . . . . . Recording as long as the alarm
signal is being input (minimum 5
seconds)
7
Press the SEARCH/AUDIO ON button to save the
settings.
NOTES:
œ During alarm recording all buttons are disabled.
œ If “OFF” is displayed on the digital display, alarm
recording is not possible in order to prevent the
recorded tape to be recorded over.
To cancel the “OFF” display, press the STOP,
EJECT or PLAY button or turn the SHUTTLE ring.
œ If an alarm trigger is received while alarm recording is
in progress, recording duration for the second alarm
will be calculated from that point. The alarm counter
will register the alarm, but it will not be found during
an alarm scan and alarm search.
œ If there is a power failure during alarm recording, and
the power is restored within the recording set
duration, alarm recording will continue.
œ If the alarm recording duration is short, the alarms
may not be found during an alarm scan or an alarm
search. If the alarms are going to be reviewed using
alarm scan or alarm search, then in 3-hour mode,
20-second or more recording duration should be
used.
œ To do alarm recording during series recording, set
“ALARM MODE” to “Y1” or “Y3”. Alarm recording will
be conducted only if the VCR is recording.
RR4Q/EX2 (TLS-9024P GB) Fri. Sept., 29/2000
18
English