Sanyo TLS-9024P - Manual (Page 24)

PROGRAMME TIMER RECORDING
NOTES:
œ During timer recording or timer recording stand-by,
all the buttons on the VCR, except the TIMER button
and the buttons to set/cancel the security lock (see
page 28), are disabled.
œ If the power fails, the recording will be interrupted.
When the power is restored, the recording will
resume if the stop time has not yet been reached,
and “P” will be displayed on the digital display. The
VCR internal battery is completely recharged after
the VCR has been connected to a live outlet for 48
hours, and it will maintain all the VCR settings
memory for up to 30 days.
œ Set the timer recordings so that the recording times
do not overlap. If they do, the one with the earliest
recording start time will have priority. (See chart
below.)
œ To set two or more timer recordings for a same day
of the week, turn the JOG dial, until the day of the
week for the second recording is flashing, then turn
the SHUTTLE ring, to set the desired day of the
week.
œ If no timer recording is set or a cassette without
erasure-prevention tab is loaded, when the TIMER
button is pressed the timer recording indicator “
n ”
will start flashing and a buzzer will be heard.
œ If “OFF” is displayed on the digital display, timer
recording is not possible in order to prevent the
recorded tape to be recorded over.
Programme 1
7:00PM
These portions will
not be recorded
10:00PM 8:00PM 9:00PM
Programme 2
Programme 3
RR4Q/EX2 (TLS-9024P GB) Fri. Sept., 29/2000
English
23