Sanyo TLS-9024P - Manual (Page 29)

TAPE COUNTER
Using the counter, it is easy to find a desired recording.
1
Press the COUNTER RESET button, at the
beginning of the desired recording.
ø The counter will be reset to “0
H
00
M
00
S
”.
2
Press the COUNTER MEMORY button.
ø “ [ ” is displayed on the digital display.
ø To cancel the counter memory function, press
the COUNTER MEMORY button a second
time.
3
After recording or playback, turn the SHUTTLE ring
counterclockwise from stop mode.
ø The tape is rewound to the counter “0
H
00
M
00
S
” reading.
ø If you rewind the tape past the “0
H
00
M
00
S
”
position, turn the SHUTTLE ring clockwise.
NOTES:
œ There is no tape counter indication for the blank
portions of the tape.
œ In the 3-hour recording speed mode only, the tape
counter indicates real hours, minutes and seconds.
œ In the other recording speed modes, the tape counter
indication is a ratio of the 3-hour mode base
indication. (In 12-hour recording mode, each
“second” of the tape counter actually represents
approximately 15/3 = 5 real seconds.)
œ There may be a slight discrepancy between the
position shown on the tape counter and the actual
tape position.
œ When rewinding the tape past the “0
H
00
M
00
S
”
position, a minus (–) sign will be displayed.
SETTING THE SECURITY LOCK
The security lock function is designed to prevent
accidental stopping of recording if the STOP button is
pressed inadvertently.
1
While holding the SHIFT « button, press the
REC/PLAY SPEED j button.
ш “ ц ” is displayed on the digital display.
To cancel the security lock, while holding the SHIFT
« button, press the REC/PLAY SPEED l button,
“ ö ” will be erased from the digital display.
NOTES:
œ While the security lock is engaged all commands,
except the one to cancel the security lock, are
disabled.
œ The security lock cannot be engaged while a menu is
displayed.
RR4Q/EX2 (TLS-9024P GB) Fri. Sept., 29/2000
28
English