Sanyo TLS-9024P - Manual (Page 14)

VIDEO CASSETTE TAPES
Correct tape thread check function
If the correct tape thread check function is on, after the
cassette tape is loaded, a mechanism will operate for
about 5 seconds to check that the tape has been
threaded (loaded) correctly and the cassette indicator
“
o ” will blink during that period. If the tape is not loaded
properly, the cassette will be ejected.
NOTES:
œ This function checks to make sure that the cassette
has been correctly loaded. It is recommended to use
this function to make sure the recordings are
conducted reliably.
œ If during the tape thread check operation, the REC,
PLAY or STOP button is pressed or if the SHUTTLE
ring is turned, the command will only be executed
after the tape thread has been checked. Only the
EJECT button will operate while the tape thread is
being checked.
1
Press the MENU button until the (SET UP 4) menu
is displayed.
@@@@@@@@<SET@UP@4>
öSW@OUT
@@FIELD@@@@@@@@@01
@@TIMING@@@@@@@@FIELD
@@3H@@@@@@@@@@@@Y
öTHREAD@CHECK@@@Y
öVIDEO@LOSS@@@@@N
öREC@SPEED@@@@@@N
2
Turn the JOG dial, until the “THREAD CHECK”
setting is flashing.
3
Turn the SHUTTLE ring, to set the desired mode.
Y . . . . . . . . . . The correct tape thread check
function is on
N . . . . . . . . . . The correct tape thread check
function is off
4
Press the SEARCH/AUDIO ON button to save the
setting.
RR4Q/EX2 (TLS-9024P GB) Fri. Sept., 29/2000
English
13