Sanyo TLS-9024P - Manual (Page 21)

ALARM RECORDING
Alarm Search
To go to the beginning of a desired alarm recording.
1
Press the SEARCH/AUDIO ON button during stop
mode.
ø “AL SEARCH 01” will be displayed on screen.
2
Press the REC/PLAY SPEED l (or j ) button to set
the desired alarm number (1 to 99), then turn the
SHUTTLE ring clockwise (or counterclockwise).
ø The desired alarm is searched and a still
image of the beginning of the alarm recording
will appear on-screen.
NOTE:
œ The alarm number is relative to the actual tape
position. (Please refer to the illustration below.)
3
Press the PLAY button.
ø Playback will start.
Alarm Scan
To look for an alarm recording by viewing the first 5
seconds of each alarm recording.
1
Press the SEARCH/AUDIO ON button twice during
stop mode.
ø “AL SCAN” will be displayed on screen.
2
Turn the SHUTTLE ring clockwise (or
counterclockwise).
ø The unit will advance (or rewind) the tape at
high speed and playback the first 5 seconds of
every alarm recording.
ø To cancel the alarm scan mode, press the
STOP
button.
3
While the desired recording is being played back,
press the PLAY button.
ø Playback will start, alarm scan mode is
cancelled.
Playback
1 1 2
Rewind direction Fast-forward direction
Actual position
Alarm number 2
Alarm trigger input point
RR4Q/EX2 (TLS-9024P GB) Fri. Sept., 29/2000
20
English