Connections – Sanyo TLS-9024P User Manual
Page 7
CONNECTIONS
Connect the video camera and monitor TV as shown in the figure below.
NOTE:
Before making the connections, make sure the devices are disconnected from the power outlet.
AUDIO
OUT
MIC IN
REMOTE
PUSH
OPEN
EXT
TIMER IN
AC IN ~
IN
VIDEO
IN
OUT
RS485
B
A
COM
WARNING
OUT
TAPE
END OUT
SW
OUT
COM
OUT
IN
ALARM
RS232C
ADDRESS
ON
OFF
485
232
TERMINATE
ON
OFF
To remote control
(sold separately)
Video camera
(sold separately)
Monitor TV (sold separately)
Coaxial cable
(sold separately)
To
VIDEO IN
jack
To
VIDEO
OUT
jack
From an external
audio source
Power
cord
To outlet
IMPORTANT NOTE (U. K. Only)
The wires in the mains lead are coloured according
to the following code:
Blue:
Neutral
Brown:
Live
If the colours of the wires in the mains lead of this
apparatus do not correspond with the colour
markings identifying the terminals in your plug,
proceed as follows:
œ
The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured blue or black.
œ
The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured brown or red.
œ
Do not connect either wire to the Earth terminal.
NOTES:
œ
For more details, please refer to the manuals
accompanying all other devices. If the connections
are not made properly, it may cause a fire or damage
the equipment.
œ
You can use a VA-RMN01 Remote Control Unit (sold
separately) to control remotely the VCR.
œ
If there is no video signal when the power is turned
on, “NO VIDEO” will be displayed on-screen.
RR4Q/EX2 (TLS-9024P GB) Fri. Sept., 29/2000
6
English