SUPER MICRO Computer SUPERSERVER 6014P-8R - Manual (Page 13)

1-3
Chapter 1: Introduction
ATI Graphics Controller
The X6DHP-8G/X6DHP-8G2 features an integrated ATI video controller
based on the Rage XL graphics chip. Rage XL fully supports sideband
addressing and AGP texturing. This onboard graphics package can provide
a bandwidth of up to 512 MB/sec over a 32-bit graphics memory bus.
Other Features
Other onboard features that promote system health include onboard voltage
monitors, a chassis intrusion header, auto-switching voltage regulators,
chassis and CPU overheat sensors, virus protection and BIOS rescue.
1-3 Server Chassis Features
The SuperServer 6014P-8/6014P-8R/6014P-82R/6014P-82 is a high-end,
scaleable server platform built upon the SC814+S-560/SC814+S-R560 1U
server chassis. The following is a general outline of the main features of
the SC814+S-560/SC814+S-R560 chassis.
System Power
6014P-8/6014P-82: the SC814+S-560 features a single 560W cold-
swappable power supply. Power must be removed from the system before
servicing or replacing the power supply.
6014P-8R/6014P-82R: the SC814+S-R560 features a redundant 560W hot-
swappable power supply (two power modules). One power supply module
will take over if the other fails. The hot-swap capability allows you to
replace a failed power supply module without powering down the system.
SCSI Subsystem
The SCSI subsystem supports up to four 80-pin SCA Ultra320 SCSI hard
drives. Any standard 1" drives are supported. (SCA = Single Connection
Attachment.) The SCSI drives are connected to a SAF-TE compliant SCA
backplane. The SCSI drives are hot-swap units. A RAID controller card
can be used with the SCA backplane to provide data security.
Note: The operating system you use must have RAID support to enable the
hot-swap capability of the SCSI drives.