SUPER MICRO Computer SUPERSERVER 6014P-8R - Manual (Page 62)

6-2
S UPER S ERVER 6014P-8/6014P-8R/6014P-82R/6014P-82 User's Manual
Figure 6-1. Chassis: Front and Rear Views
UID Button and LED
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected
to the JF1 connector on the serverboard to provide you with system status
indications. A ribbon cable has bundled these wires together to simplify the
connection. Connect the cable from JF1 on the serverboard to the appro-
priate header on the Control Panel PCB (printed circuit board). Make sure
the red wire plugs into pin 1 on both connectors. Pull all excess cabling out
of the airflow path.
The control panel LEDs inform you of system status. See "Chapter 3:
System Interface" for details on the LEDs and the control panel buttons.
Details on JF1 can be found in "Chapter 5: Advanced Serverboard Setup."
Control Panel
System LEDs Main Power
Slim DVD-ROM Drive Slim Floppy Drive
SCSI Drives
PCI Expansion Slots Power Supply
VGA Port Mouse/Keyboard Ports External SCSI Port
GLAN Ports
USB0/1 Ports UID Button/LED
6014P-8/6014P-82*
6014P-8R/6014P-82R*
PCI Expansion Slot Power Supplies GLAN Ports
VGA Port Mouse/Keyboard Ports External SCSI Port USB0/1 Ports UID Button/LED
COM Port
COM Port
* The 6014P-82 and 6014P-82R have an additional PCI expansion slot made available with a riser
card installed into the onboard IMPI slot.