SUPER MICRO Computer SUPERSERVER 6014P-8R - Manual (Page 20)

2-4
S UPER S ERVER 6014P-8/6014P-8R/6014P-82R/6014P-82 User's Manual
2-4 Installing the System into a Rack
This section provides information on installing the system into a rack unit
with the rack rails provided. If the system has already been mounted into a
rack, you can skip ahead to Sections 2-5 and 2-6. There are a variety of
rack units on the market, which may mean the assembly procedure will
differ slightly. You should also refer to the installation instructions that
came with the rack unit you are using.
Identifying the Rack Sections
You should have received a rack mounting kit with the server. The kit
includes four rail sections for each side of the server. The two front
chassis rails have already been attached to the chassis. An additional
chassis rail and two rack rails (for each side of the servr) are also included
in the mounting kit. (See Figure 2-1).
Chassis Rails
The front chassis rails should have already been installed to the chassis
with flat head screws. Check to make sure that both are securely at-
tached, then use screws to secure the rear chassis rails to the chassis so
that they are flush against the rear end of the front rails (see Figure 2-2).
Figure 2-1. Identifying the Sections of the Rails
(right side rail assembly shown)