Smart Technologies Smart Board 6055i/8055i SMP/8055ie-SMP - Manual (Page 29)

4. Pull the black jumper off of the circuit board with the pliers.
C A U T I O N
To prevent damage to the circuit board, do not touch the circuit board with the pliers.
I M P O R T A N T
You can install the jumper again to enable the USB receptacle.
Connecting peripheral devices to your interactive
flat panel
Connect peripheral devices to the bottom terminal panel.
C A U T I O N
The AC power outlet is designated for a component of the SMART Board 8055ie-SMP interactive
flat panel with appliance. See Replacing the appliance on your SMART product (FRU - Appliance -
SB8) ( smarttech.com/kb/170062 ).
Bottom terminal panel
g To connect a peripheral device
1. Turn off the interactive flat panel and the peripheral device.
2. Connect the peripheral device’s input cables to the appropriate connectors on the bottom
terminal panel.
N O T E
You can secure these cables with the included large clamps.
3. Turn on the interactive flat panel, and then turn on the peripheral device.
C H A P T E R 3
Connecting computers and peripheral devices
21