Smart Technologies Smart Board 6055i/8055i SMP/8055ie-SMP - Manual (Page 54)

Using the USB receptacle
You can connect a USB drive or device to the USB A receptacle on the side terminal panel on your
interactive flat panel, and then access it from computer 1 connected to VGA 1 and USB 1.
N O T E
To disable the USB A receptacle on the side terminal panel, see Disabling the USB receptacle on
the side terminal panel on page 20.
g To use the USB receptacle
1. Press the VGA 1 button on the remote control.
Press the Input button on the front control panel until the input source is VGA 1.
2. Connect a USB device to the USB receptacle.
3. Use computer 1 to access the content on your USB device.
C H A P T E R 5
Using your interactive flat panel
46