Smart Technologies Smart Board 6055i/8055i SMP/8055ie-SMP - Manual (Page 4)

l
Do not move or mount the interactive flat panel by connecting rope or wire to its handles.
Because the interactive flat panel is heavy, rope, wire or handle failure could lead to personal
injury.
l
Use only VESA®-approved mounting hardware.
l
Disconnect all power cables for your interactive flat panel from the wall outlet and seek
assistance from qualified service personnel when any of the following occurs:
o The power cable or plug is damaged
o Liquid is spilled into the interactive flat panel
o Objects fall into the interactive flat panel
o The interactive flat panel is dropped
o Structural damage such as cracking occurs
o The interactive flat panel behaves unexpectedly when you follow operating
instructions
C A U T I O N
l
Before you clean your SMART product, shut down or disconnect the computer. Otherwise,
you may scramble the desktop icons or inadvertently activate applications when you wipe
the screen.
l
Avoid setting up and using the SMART product in an area with excessive levels of dust,
humidity and smoke.
l
Make sure an electrical socket is near your SMART product and remains easily accessible
during use.
l
For SMART Board 8055ie-SMP interactive flat panel only: The external power supply needs
to meet the Limited Power Source (LPS) requirements of CSA/UL/IEC/EN 60950-1, when
required.
l
This SMART product should be used only with European TN and TT power distribution
systems.
It is not suitable for older, IT-type power distribution systems found in some European
countries. "This system (IT-type) is widely used isolated from earth, in some installations in
France, with impedance to earth, at 230/400V, and in Norway, with voltage limiter, neutral
not distributed, at 230V line-to-line." (IEC 60950:1999)
Contact qualified personnel if you’re uncertain of the type of power system available where
you’re installing your SMART product.
I M P O R T A N T I N F O R M A T I O N F O R Y O U R I N T E R A C T I V E F L A T P A N E L
ii