Smart Technologies Smart Board 6055i/8055i SMP/8055ie-SMP - Manual (Page 86)

Menu item Function
CARBON SAVINGS Displays the estimated carbon saving information in kilograms.
OSD RESET Restores the OSD settings to their default values.
Setup settings
Menu item Function
POWER SAVE When enabled, and there isn't a video input, the interactive flat panel
displays No Signal for 25 seconds before turning off.
N O T E
When you connect a DVI video cable, the video card might not stop
sending digital data even if there is no image. In this case, the
interactive flat panel doesn’t enter Power Save mode.
STANDBY MODE Lowers power consumption. Select either NORMAL or
ECO STANDBY.
I M P O R T A N T
When ECO STANDBY mode is enabled, presence detection is
disabled and you cannot wake the computer by touching the
interactive flat panel’s screen.
N O T E
You can’t use RS-232C Functions in ECO STANDBY mode.
DDC CI ENABLE/DISABLE: turns on or off the two-way communication and
control of the interactive flat panel.
SCAN MODE Sets the scanning mode. Some video formats might require different
modes to display the best image.
PROXIMITY CONTROL Sets the proximity sensor settings. See Proximity control settings on
the next page.
HEAT STATUS Displays the FAN, BRIGHTNESS and TEMPERATURE settings.
FAN CONTROL Sets the cooling fan to protect the interactive flat panel from
overheating. When selected, you can adjust the start temperature of the
cooling fan and its speed.
USB SETTING Configures the video and touch input. See Configuring the video and
touch input for your SMART Board 8055i interactive flat panel
( smarttech.com/kb/170190 ).
SETUP PRESET Restores the setup settings to their default value.
FACTORY RESET Restores OSD menu options to default values for all items, except for
LANGUAGE.
A P P E N D I X A
Adjusting video settings with the on-screen display menu
78