Smart Technologies Smart Board 6055i/8055i SMP/8055ie-SMP - Manual (Page 57)

I M P O R T A N T
Your interactive flat panel supports the SMART GoWire cable with SMART Meeting Pro software
only. It does not support the SMART GoWire cable with SMART Notebook software.
g To use a SMART GoWire cable
1. Connect a video cable from your interactive flat panel to your laptop.
2. Connect the USB cable from the USB receptacle on your interactive flat panel to your laptop.
3. Change the video input to your laptop's video connection using the remote control or the front
control panel.
4. Disconnect the USB cable from your laptop, and then connect it to the SMART GoWire cable’s
USB A receptacle.
I M P O R T A N T
If the SMART GoWire cable is not connected to your interactive flat panel through a USB
cable, you have access to SMART Meeting Pro software on your laptop for five minutes, and
then the software closes.
5. Connect the SMART GoWire cable’s USB connector to your laptop.
The AutoPlay dialog box appears.
6. Select Start SMART Meeting Pro.
SMART Meeting Pro software starts. You have touch control of your laptop on your interactive
flat panel and can use SMART Meeting Pro software while your laptop is connected to your
interactive flat panel.
g To disconnect a SMART GoWire cable
1. If required, save your SMART Meeting Pro software file to your laptop. You can save the file as
a .ppt, .pdf or .notebook file.
I M P O R T A N T
You can open a .notebook file on a computer that has SMART Meeting Pro software or
SMART Notebook software installed or that is connected to a SMART product through a
SMART GoWire cable only.
2. Press the SMART Meeting Pro icon in the notification area, and then select Exit.
3. Disconnect the SMART GoWire cable from your laptop and the USB cable.
C H A P T E R 6
Using guest laptops with your interactive flat panel
49