Standard Horizon CPV350 - Manual (Page 110)

Page 110 CPV350
19.7.2 Receiving a Position Request
When a position request call is received from another vessel, a ringing
alarm will sound and POS REQUEST will be shown in the LCD.
Operation and transceiver function differs depending on “POS
REQUEST REPLY” in the “DSC Setup” menu setting.
Automatically reply:
1. When a position request call is received, a calling alarm sounds 4 times. Then requested
position coordinates are transmitted automatically to the vessel requesting your vessels
position.
2. To exit from position request display, press any key.
Manually reply:
1. When a position request call is received from another vessel, the “RECEIVED DSC
CALL” window will open.
2. Press [ENT] to transmit your position to the requesting vessel and exit from position
request display. Press [CLR] to exit from position request display without the transmitting
your position (No Reply).
19.8 POSITION SEND
The feature is similar to Position Request, however instead of requesting a position of
another vessel this function allows you to send your position to another vessel.
19.8.0 Setting up a Position Send Ringer
The CPV350 has the capability to turn off the Position Send ringer.
1. Press [MENU] two times. Move the ShuttlePoint knob to highlight RADIO SETUP and
press [ENT] or move the ShuttlePoint knob to the right.
2. Move the ShuttlePoint knob to highlight DSC SETTINGS and press [ENT] or move the
ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight RINGER OUTPUT and press [ENT] or move
the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to select POS SEND and press [ENT] or move the
ShuttlePoint knob to the right.
5. A popup window will be shown with On or Off, move the ShuttlePoint knob to select Off
and press [ENT] or move the ShuttlePoint knob to the right.
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
To enable the ringer, repeat the above procedure, moving the ShuttlePoint knob to select
On in step “5” above.