Standard Horizon CPV350 - Manual (Page 57)

Page 57 CPV350
11.1 USING THE TRIP LOG
On the Chart, Navigation, Highway and NMEA Data pages the windows may be customized
to show TRIP LOG information.
Figure 11.1 - Using the Trip Log
1. Select one of the pages listed above, press and hold [MENU]. You will notice one of the
data boxes will be highlighted.
2. Press [ENT] and move the ShuttlePoint knob to highlight TRIP LOG, press [ENT] or
move the ShuttlePoint knob to the right.
3. A popup window will be shown with Nm (Nautical Mile), Sm (Statute Mile), Km
(Kilometer) and RESET. Move the ShuttlePoint knob to select the desired units of
measure and press [ENT] or move the ShuttlePoint knob to the right.
4. Press [CLR] or move the ShuttlePoint knob to the right until the selected page (Chart,
Navigation, Highway or NMEA Data Page) is shown.
11.1.0 Resetting the Trip Log
Select the page with TRIP LOG in one of the data windows as setup in the “Using the TRIP
LOG” section.
1. Press and hold [MENU], move the ShuttlePoint knob to highlight TRIP LOG.
2. Press [ENT] or move the ShuttlePoint knob to the right to show a popup window, select
RESET and press [ENT] or move the ShuttlePoint knob to the right.
3. A Warning popup window will be shown to confirm if you want to reset the Trip Log. Using
the ShuttlePoint knob select YES and press [ENT]. The Trip Log is now reset.