Standard Horizon CPV350 - Manual (Page 32)

Page 32 CPV350
6. CONTROLS AND INDICATORS
LEGEND
[MENU] If you see brackets around a bold and capital letter word this refers to a key press.
[CHART] If you see brackets around a bold and small capital letter word this refers to a Soft Key
press. When a word(s) is bold capital letters and underlined, this refers to a menu selection item.
6.0 CONTROLS AND CONNECTIONS
The GPS Chart plotter, VHF radio, PA and optional FF520 fish finder are controlled using the
keys located on the front panel. These labeled keys are dedicated to specific functions. As you
press a key, a single audio beep confirms the key action; every time a key press is not valid,
three rapid beeps sound to indicate that the key action is not valid. There is also a ShuttlePoint
knob to move the cursor across the screen.
The ZOOM key
Pressing this key enables or disables the chart plotter zoom function or VHF channel
selection.
Press the [ZOOM] key and a zoom icon will appear on the top left of the display as shown
below. When this icon is shown the zoom function is enabled and the channel selector knob
is used to change the zoom levels. When the icon is not shown turning the knob changes
the VHF channels.
To zoom in rotate the channel selector knob Clockwise (up) or to zoom out rotate the
channel knob counter clockwise (down). When finished zooming press the [ZOOM] key.
Rotating the channel knob.
NOTE
The GPS chartplotter contains a Worldwide background that allows you to zoom into 2 NM. For
more detail, a C-MAP NT
+ /MAX C-CARD must be purchased and installed.
The ShuttlePoint knob
The ShuttlePoint knob moves the cursor about on the display screen, quickly and
accurately. It also scrolls the desired option in the menu page(s). It allows to exit from Home
mode to Cursor mode. when the setup menu is selected, moving the knob to the right selects
the desired option, as [ENT], moving it to the left exits from menu, as [CLR]. For a detailed
explanation of Cursor VS Home mode refer to section 6.1.1.
The ENT key
Press [ENT] to select the desired option or to confirm selection.
The CLR key
Press [CLR] to set Home mode. Also press [CLR] to exit from menu or data windows or to
leave a menu without making changes, to abort selected function or to step backward from
a selection made in the menu.
The MENU key
Pressing [MENU] one time selects the Main Menu. While the Main Menu is shown, move
the ShuttlePoint knob up or down or left or right to highlight a selection. Press the [ENTER]
to choose the selection.
Pressing [MENU] two times selects the Setup Menu.