Kodak HR 500 - Manual (Page 57)

Using the Service and Assembly Module (SAM)
August 2001 A-7
Setting Image Processing Parameters
1. Select the Data Path.
2. Select the LUT Selected.
3. Select the Dmin Settings.
4. Select the Colors Selected.
5. Select:
• Enable Dark and Gain Corrections
• Enable Defective Pixel Conceal
• Shift Image Data Bits Up by Four
Calibrating the Scanner
IMPORTANT: The 70MM-CAL film holder must be in position in the scanner
before you continue. See Placing the Empty Film Holder in the Film
Holder Guide on page 2-6.
1. If the values on the Calibrate/Image Processing tab do not match the values
shown on the sample on page A-6, change them. The sample is a
representation of the default values.
2. Select Shift Image Data Bits Up by Four.
3. Click Calibrate All.