Kodak HR 500 - Manual (Page 79)

Using the Long Roll Accessory
August 2001 D-13
4. Center the aperture plate on the lamphouse cover.
5. Gently lower the aperture plate and, when you feel resistance, push until it is
secured.
Removing the Long Roll Accessory from the Scanner
It may be necessary to remove the Long Roll Accessory from the scanner.
CAUTION: Make sure the scanner is powered OFF.
To remove the Long Roll Accessory, reverse the installation procedure (see pages
D-8 through D-12 for more details):
1. Remove the aperture plate from the Long Roll Accessory. See Latching and
Unlatching the Gate Actuator on page D-11.
2. Power off the scanner.
CAUTION: When removing the mounting screws in the next step, use
care to avoid dropping the screws inside the scanner.
3. Loosen and remove the 3 mounting screws.
CAUTION: Avoid hitting the light bar and the safety switch.
4. Remove and lift the Long Roll Accessory from the scanner.
5. Place the Long Roll Accessory on a flat surface.
P192_1547AC
plate
aperture
P192_1547ACA