Kodak HR 500 - Manual (Page 82)

Using the Long Roll Accessory
D-16 August 2001
Loading and Threading Film
IMPORTANT: Careful handling of film is extremely important. Before loading film,
clean the film with Super Film Cleaner or an equivalent cleaner that
has ionized air and particle transfer rollers (PTR).
Use canned air to clean the punch readers before threading film.
Before loading film, make sure you have at least 2 feet (.6 meters)
of leader at each end of the roll.
CAUTION: In the steps below, be sure you determine and use the correct
orientation of the flange. Incorrect setup will result in film tracking
problems and loose takeups.
1. Determine the orientation of the flange for the reel or core you selected for
loading:
• A flange in the upright position is for thin reels
• A flipped flange is for film on cores
• No flanges are needed for thick reels
P192_1549GC
or
THIS SIDE UP FOR THIN REEL
REMOVE FOR THICK REEL
REMOVE FOR THICK REEL
THIS SIDE UP FOR CORE ONLY
P192_1549GCA
flange
spindle