Kentrox AI232 - Manual (Page 218)

AI232 Version 9.6x User’s Guide
AI232 Commands: diag-info
8-46
This example displays diagnostic information for asynchronous connections, which is
accessed by typing
A . This is the default display.
CNT_HWM Displays the highest number of blocks allocated since AI232 was last
reset.
USED Displays the number of bytes currently allocated from a region.
USED_HWM Displays the highest number of bytes allocated since AI232 was last
reset.
UNIT_SIZE Displays the size in bytes of the memory units that can be allocated.
ASYNC DIAG INFO
LINK STATE BYTES_IN BYTES_OUT LINK STATE BYTES_IN BYTES_OUT
1 1 0 0 16 0 0 0
2 1 0 0 17 0 0 0
3 1 0 0 18 0 0 0
4 0 0 0 19 0 0 0
5 0 0 0 20 0 0 0
6 0 0 0 21 0 0 0
7 0 0 0 22 0 0 0
8 0 0 0 23 0 0 0
9 0 0 0 24 0 0 0
10 0 0 0 25 0 0 0
11 0 0 0 26 0 0 0
12 0 0 0 27 0 0 0
13 0 0 0 28 0 0 0
14 0 0 0 29 0 0 0
15 0 0 0 30 0 0 0
16 0 0 0 31 0 0 0
17 0 0 0 32 0 0 0
Enter M-emory, A-sync, E-thernet, T-cp or Q-uit:
Column Description
LINK Displays the link number.
STATE Displays the state of the driver. Two states are available:
z 0 specifies that the link is not established.
z 1 specifies that the link is enabled. The link does not have to have a
connection to be enabled.
BYTE_IN Displays the number of bytes coming into the link.
BYTE_OUT Displays the number of bytes going out of the link.
Column Description