Lexicon Digital Controller MC-12 - Manual (Page 61)

MC-12 Setup
3-17
INPUT SELECT PARAMETER SETTINGS
DIGITAL ANALOG AUTO
The MC-12 sends the digital audio from the
assigned input to the Main Zone audio
output connectors. The assigned analog
audio input connector is ignored.
The digital audio input connectors are
compatible with PCM (44.1, 48, 88.2,
and 96kHz), Dolby Digital, and DTS(-ES)
s o u rc e s . T h e d i g i t a l a u d i o i n p u t
connectors are not compatible with
MPEG or MP3 sources.
Note the following:
• The MC-12 automatically sets the
INPUT SELECT parameter to DIGITAL
w h e n n o a n a l o g a u d i o i n p u t
connector is assigned.
• The INPUT SETUP DIGITAL IN
parameter can assign a digital audio
input connector for the selected
input.
The MC-12 sends the analog audio from the
assigned input to the Main Zone audio output
connectors. The assigned digital audio input
connector is ignored.
Note the following:
• The MC-12 automatically sets the INPUT
SELECT parameter to ANALOG when no
digital audio input connector is assigned.
• The INPUT SETUP ANALOG IN
parameter can assign an analog audio
input connector for the selected input.
• When LIVE! is the selected analog input,
the MAIN ADVANCED
INPUT SELECT
parameter is forced to ANALOG and
ANALOG BYPASS is disabled.
The MC-12 toggles between sending digital or
analog audio input to the Main Zone audio output
connectors based on the input source that is
present.
Example:
• The MC-12 selects the assigned digital
audio input when a compatible digital
source is present. The MC-12 does not
select the assigned analog audio input
w h e n a c o m p a t i b l e d i g i t a l s o u rc e i s
present.
• The MC-12 selects the assigned analog
audio input connector when no compatible
digital source is present.
• The MC-12 selects the assigned analog
connector if no digital source is present.
• The MC-12 selects the assigned analog
audio input connector when an analog
source, such as an SACD, is present.
Note the following:
• The MC-12 automatically sets the MAIN
ADVANCED
INPUT SELECT parameter to
AUTO when both digital and analog audio
input connectors are assigned.
• Use the AUTO setting for components, such as
DVD/SACD players, that generate both digital
and analog output signals.