Installation – Lincoln Electric POWER FEED SVM185-A User Manual
Page 18
INSTALLATION
A-10
A-10
POWER FEED® 25M
TYPICAL SYSTEM CONFIGURATIONS
Standard Features
Arc Performance
• Push-Pull ready for welding aluminum with Pulse
and Pulse-on-Pulse™ waveforms.
• STT™ capable when used with STT™ equipped
Power Waves.
• Waveform Control Technology™ for welds with good
appearance and low spatter, even when welding
nickel alloys.
User Interface
• 6 memories for easily selecting procedures.
• MSP4 panel located behind the memory panel door
for protection.
• Full sequence control for tailoring the weld from start
to end.
• All welding controls located at the wire feeder, includ-
ing process selection.
Wire Drive
Patented 2 roll drive system. MAXTRAC™ technology
delivers great feeding because:
• Patent pending drive rolls improve traction on solid
wire by up to 20%.
• The precision machined, rigid aluminum alloy frame
results in maximum drive roll clamping pressure.
• Patented split wire guides fully support the wire and
virtually eliminate birdnesting.
• No tools required to change the drive rolls and wire
guides.
• Patented dual spring pressure arms have sensitivity
for feeding soft wires without crushing them, and
have plenty of compression force for feeding solid or
stiff wires.
• All gear driven rolls for more feeding force.
• Changeable gun bushings easily accept guns from
other manufacturers.
• Brass-to-brass connections between the electrode
connection and the gun minimize voltage drop varia-
tions, resulting in consistent arc performance all day,
every day.
• Powerful, quiet motor with integrated tachometer for
accurate WFS regulation.
Extras
:
• Flowmeter with gas control valve
• Push-Pull ready.
• Remote control / Foot amptrol ready.
• Internal heater for keeping condensation off of the
spool of wire.
• Internal lights for illuminating the wire drive compart-
ment.
Options
• Water cooling kit for use with water cooled guns.