Operation – Lincoln Electric POWER FEED SVM185-A User Manual
Page 47
OPERATION
B-29
B-29
POWER FEED® 25M
USER MEMORIES
Recall a memory with memory buttons
To recall a user a memory, press one of the six user
memory buttons. The memory is recalled when the but-
ton is released. Do not hold the button for more than
two seconds when recalling a user memory.
Recall a memory with the gun trigger
If desired, memories 2 through 6 can be recalled with
the gun trigger. For example, to recall memory 3, quick-
ly pull and release the gun trigger 3 times without weld-
ing.
Note: the POWER FEED® Wire Feeders are factory
set with this feature disabled. Use the SETUP menu
and change P.4 to enable memory recall with the gun
trigger.
Save a memory with memory buttons
To save a memory, press and hold the desired memo-
ry button for two seconds. When the button is initially
pressed, the corresponding LED will illuminate. After
two seconds, the LED will turn off. Do not hold the but-
ton for more than 5 seconds when saving a user mem-
ory.
Note that memories may be locked using Weld
Manager from a P.C. or Palm application to prevent
accidental overwrite of the memories. If an attempt is
made to save a memory when memory saving is
locked, the message "Memory save is Disabled!" will
appear briefly in the MSP4 display.
HOLD 2 SECONDS TO SAVE
PROCEDURE
MEMORY
A
GUN
B
1
4
2
5
3
6
M
M
PROCEDURE/MEMORY PANEL OPERA-
TION
The Dual Procedure/Memory Panel performs three
functions:
• Weld procedure selection
• Memory save and recall
• Limits setting
There are two procedure memories (A and B) and six
user memories (1-6).
Procedure Memory vs. User Memory
Procedure memory is used while welding. Changes to
the weld procedure (WFS, voltage, arc control, etc.)
immediately change the contents inside the selected
procedure memory.
User memories work by copying the weld procedure
from one of the six memories into either the A or B pro-
cedure. Weld procedures are saved into the memories
only when the operator chooses.
Using Procedure Memories
Procedure memories can be selected by choosing
either "A" or "B" procedure directly with the memory
panel, or by selecting "GUN" and using a dual proce-
dure gun to select between procedure "A" and "B".
When selecting procedures with the gun switch, "A" or
"B" will flash to show which procedure is active.
HOLD 2 SECONDS TO SAVE
PROCEDURE
MEMORY
A
GUN
B
1
4
2
5
3
6
M
M
HOLD 2 SECONDS TO SAVE
PROCEDURE
MEMORY
A
GUN
B
1
4
2
5
3
6
M
M
RECALL
PRESS 1
SECOND
SAVE
PRESS 2
SECONDS
PROCEDURE
MEMORY
PRESS TO
SELECT
PROCEDURE OR
QUICK TRIGGER-
WHILE
WELDING
USER
MEMORIES