The Setup Menu gives access to the set-up configura-
tion. Stored in the set-up configuration are user para-
meters that generally need to be set only at installation.
The parameters are grouped as follows:

• P.1 through P.99 Unsecured Parameters (always

adjustable)

• P.101 through P.199 Diagnostic Parameters (always

read only)

• P.501 through P.599 Secured Parameters (accessi-

ble only though a p.c. or palm application.)

To access the set-up menu, press the right and left but-
tons of the MSP4 panel simultaneously. Note that the
set-up menu cannot be accessed if the system is weld-
ing, or if there is a fault (The status LED is not solid
green).

Change the value of the blinking parameter by rotating
the SET knob.

After changing a parameter it is necessary to press the
right hand button to save the new setting. Pressing the
left button will cancel the change.

To exit the set-up menu at any time, press the right and
left buttons of the MSP4 panel simultaneously.
Alternately, 1 minute of inactivity will also exit the set-
up menu.

The following list includes all possible parameters
in ArcLink® equipment. Not all of the parameters
listed may appear for your system. Refer to Table
B.1 for active parameters.

PARAMETER

P.0
P.1
P.2
P.4
P.5
P.6
P.7
P.8

P.11
P.12
P.13
P.80
P.99

DESCRIPTION

Exit set-up menu

WFS Units

Arc Display Mode

Trigger Memory Recall

Trigger Procedure Change

Stall Factor Adjustment

Gun Offset Adjustment

TIG Gas Control

Set Timers

Travel Options

Adjust Arc Force

Sense From Studs

Show Test Modes

View Diagnostics

View Event Logs

View Fatal Logs

View Software Version

View Hardware Version

View Welding Software

View Ethernet IP Address

View Power Source Type

P.100
P.101
P.102
P.103
P.104
P.105
P.106
P.107

Unsecured Parameters

Diagnostic Parameters

POWER FEED®

10M (All Models)

POWER

FEED® 10A

POWER

FEED® 25M

TABLE B.1

Advertising

Popular Brands

Popular manuals