Lexmark 2480 - Manual (Page 101)

97
Using Setup mode
Character options
(continued)
Note: Available for
the 2480/2481 printers
only.
20-Pitch
This setting enables or disables the 20-pitch mode, and
provides compatibility with other IBM printers.
• When set to Enable, switching from 12 cpi to condensed
(Dec 15, Hex 0F) changes the pitch from 12 cpi to 20 cpi.
• When set to Disable, switching from 12 cpi to condensed
(Dec 15, Hex 0F) does not change the pitch.
Paper handling
options Auto Tear Off
• When set to On, Auto Tear Off moves continuous form
paper to the Tear Off bar.
• When set to One Second, continuous form paper
automatically advances to the Tear Off bar after a one
second delay in receiving data.
• When set to Off, you can manually advance the
perforation of a continuous form to the Tear Off bar.
Auto Cut Sheet Load
• When set to On, paper is loaded into the manual feed
tray, the printer automatically loads the paper to the
current Top-Of-Form.
• When set to Off, press FormFeed to load paper.
Auto Sheet Feeder
If you installed the optional Auto Sheet Feeder, turn the
Auto Sheet Feeder setting On to automatically load paper
into the printer.
Tractor
Lets you select the default tractor if the optional tractor is
installed. Selecting Tractor 1, Tractor 2, or Tractor 1+ 2 makes
the specified tractor or tractor set the default.
Form Length
You may set the form length (in lines per page) from one
line to a maximum of 22 inches.
Macro options (continued)
Use these menu
options
When you want to customize…