Lexmark 2480 - Manual (Page 69)

65
Loading paper
18 Open the operator panel cover to access layer 2.
19 Press Micro
↑
, Micro
↓,
or LineFeed to move
the paper to the Top-Of-Form you want to use.
Note:
• Use the second form to set Top-Of-Form
alignment.
• To do this, align the horizontal lines (located on
the platen) with the Top-Of-Form you want. To
see an illustration, go to ” on pag e83.
20 Press Set TOF to set Top-Of-Form.
Top-Of-Form is not saved if the printer is turned
Off or runs out of paper when using the pull
tractor.
21 Make sure the printer is online (Ready light is
On solid).
If not, press Start/Stop until the Ready light is
On solid.