Setting printer to default settings, Initialize printer to us defaults – Lexmark 2480 User Manual
Page 125
Advertising
121
Tr
oubleshooting
Setting printer to default settings
To reset the printer to the factory defaults:
Initialize printer to US defaults
The standard defaults for the United States are:
•
Code page: 437
•
Character Set: 1
•
Form length: 11”
To change the defaults:
1
Make sure paper and the ribbon cartridge are
installed.
2
Turn the printer Off.
3
Open the ribbon access cover.
4
Move the printhead over toward the operator
panel side of the printer until it stops.
5
Close the ribbon access cover.
6
Press and hold Tear Off + Load/Unload while
you turn the printer On.
7
Continue holding these buttons until the carrier
moves.
Note: The operator panel lights blink On and
Off several times.
Once the carrier moves, your settings have been reset
to factory defaults.
Advertising