Installation, Electrical output connections – Lincoln Electric WELDANPOWER SVM 113-A User Manual
Page 11
ELECTRICAL OUTPUT
CONNECTIONS
See Figure A.1 for the location of the current control
dial, weld output terminals, ground stud, circuit break-
ers, 230 and 115 volt receptacles.
WELDING CABLE CONNECTIONS
Cable Size and Length
Be sure to use welding cables that are large enough.
The correct size and length becomes especially impor-
tant when you are welding at a distance from the
welder.
Table A.1 lists recommended cable sizes and lengths
for rated current and duty cycle. Length refers to the
distance from the welder to the work and back to the
welder. Cable diameters are increased for long cable
lengths to reduce voltage drops.
TABLE A.1
RECOMMENDED WELDING CABLE
SIZE AND LENGTH
TOTAL COMBINED LENGTH OF ELECTRODE AND
WORK CABLES
Cable Size for
125 amp/
Cable Length
30% Duty Cycle
0-50 feet (0-15 meters)
6 AWG
50-100 feet (15-30 meters)
5 AWG
100-150 feet (30-46 meters)
3 AWG
150-200 feet (46-61 meters)
2 AWG
200-250 feet (61-76 meters)
1 AWG
INSTALLATION
A-5
A-5
WELDANPOWER 125
FIGURE A.1 - WELDANPOWER 125 OUTPUT CONNECTIONS
1. CURRENT CONTROL DIAL
2. WELD OUTPUT TERMINALS (2)
3. GROUND STUD
4. CIRCUIT BREAKERS (2) - 20 AMP (15 AMP CSA)
5. RECEPTACLE - 230 VOLT, 20 AMP (15 AMP CSA)
6. DUPLEX RECEPTACLE - 115 VOLT, 20 AMP (15 AMP CSA)
1
6
5
4
3
2